History

tmk 6b71d88150 xt_usb: Fix Pause of Code Set1(XT)		2020-11-22 04:21:16 +09:00
..
binary	xt_usb: Fix */PrtSc key issue #552	2018-10-06 22:37:16 +09:00
config.h	xt_usb: Clear flag before enabling interrupt	2018-03-14 21:32:22 +09:00
keymap.c	xt_usb: Fix */PrtSc key issue #552	2018-10-06 22:37:16 +09:00
keymap_common.h	xt_usb: Fix */PrtSc key issue #552	2018-10-06 22:37:16 +09:00
led.c	Codes appear to be detected correctly, the break codes are broken.	2016-03-01 21:37:22 -08:00
Makefile	Remove INTERRUPT_CONTROL_ENDPOINT from converters	2020-05-08 22:39:55 +09:00
Makefile.unimap	xt_usb: Add unimap	2018-04-25 02:25:34 +09:00
matrix.c	xt_usb: Fix Pause of Code Set1(XT)	2020-11-22 04:21:16 +09:00
README.md	xt_usb: Update README	2018-04-25 02:57:29 +09:00
unimap.c	xt_usb: Fix */PrtSc key issue #552	2018-10-06 22:37:16 +09:00
unimap_common.h	xt_usb: Fix comment of scancode	2020-10-27 04:28:01 +09:00

XT to USB keyboard converter

This firmware converts XT keyboard protocol to USB.(It supports Scan Code Set 1.)

Connect Wires

Connect Vcc and GND.
Connect Clock and Data line. Clock is on PD1, Data on PD0 by default. And optionally you can use PB7 for Reset.(Compatible to Soarer's converter) To change pin configuration edit config.h.
You need pull-up resistor. 1K-10K Ohm will be OK.

Just run make:

$ make clean
$ make

To use your own keymap create keymap_<name>.c file and then:

$ make clean
$ make KEYMAP=<name>

After that you will find HEX file xt_usb.hex in current directory.

See wiki pages on github for further information. https://github.com/tmk/tmk_keyboard/wiki